Yamyam: 1版をインポートしました

2018-06-28T20:44:35Z

1版をインポートしました

2011年12月29日 (木) 20:43にwiki>Josefによる

2011-12-29T20:43:11Z

新規ページ

=Edge Marks and Face Marks in Freestyle=

[[file:Manual-Part26-freestyle-mark-freestyle-edge.png|thumb|Select and mark Freestyle Edges]]
[[file:Manual-Part26-freestyle-edge-mark.png|thumb|Edge Mark setting in the Line Sets tab]]
With Edge and Face Marks you can select individual edges to be rendered with Freestyle, giving you alot of control over the rendered lines.

==Using Edge Marks==

In edit mode you can mark "Freestyle Edges" in the same manner you can "Mark Seam" for UV unwrapping or "Mark Sharp" for edge split. These marked edges are available to render when you select "Edge Mark" under "Selection by Edge Types" in the Line Set panel.

This is done as follows:

* Select your mesh and tab into edit mode.
* Select the edges you want to be marked.
* Press {{shortcut|crtl|E}} and select "Mark Freestyle Edge".

Edge marks are useful when you want to draw lines along particular mesh edges. They give alot of control over the edges that are rendered. The examples below explains the use of Edge marks.
{|align = center
|[[file:Manual-Part26-freestyle-edge-marks-viewport.png|thumb|Marking Freestyle Edges in edit mode]]
|[[file:Manual-Part26-freestyle-edge-marks-disabled.png|thumb|Render without Edge Marks]]
|[[file:Manual-Part26-freestyle-edge-marks-enabled.png|thumb|Render with Edge Marks enabled]]
|}
The image on the left shows a sphere in edit mode. the green lines are the edge marks. on the right you see a render without edge marks enabled.
With Edge Marks enabled, the previously marked lines are always rendered. You can see the black contour lines and the blue lines that are made with edge marks.

==Using Face Marks==
To set a Face Mark:

* Select a mesh and tab into edit mode.
* Select the faces you want to be marked
* Press {{shortcut|ctrl|F}} and select 'mark freestyle face'
[[file:Manual-Part26-freestyle-mark-freestyle-face.png|thumb|Mark Freestyle Faces]]

Face Marks are useful for removing lines from certain areas of a mesh. In this example two faces of the default cube are marked like the image on the left. on the right is a render without 'selection by face marks' activated.
{|align = center
|[[file:Manual-Part26-freestyle-face-marks-viewport.png|thumb|Marked Faces]]
|[[file:Manual-Part26-freestyle-face-marks-disabled.png|thumb|Render Output]]
|}

[[file:Manual-Part26-freestyle-face-mark.png|thumb|Face Mark options]]

The line selection can be controlled via inclusion and faces options. The image below shows the resulting combinations.

{|align = center
|[[file:Manual-Part26-freestyle-face-mark-inclusive-one.png|thumb|Inclusive, One Face]]
|[[file:Manual-Part26-freestyle-face-mark-inclusive-both.png|thumb|Inclusive, Both Faces]]
|}
{|align = center
|[[file:Manual-Part26-freestyle-face-mark-exclusive-one.png|thumb|Exclusive, One Face]]
|[[file:Manual-Part26-freestyle-face-mark-exclusive-both.png|thumb|Exclusive, Both Faces]]
|}

← 古い版	2018年6月28日 (木) 20:44時点における版
(相違点なし)

利用者:Flokkievids/Freestyle/freestyle edges - 版の履歴

Yamyam: 1版 をインポートしました

2011年12月29日 (木) 20:43にwiki>Josefによる

Yamyam: 1版をインポートしました