Yamyam: 1版をインポートしました

2018-06-28T19:42:02Z

1版をインポートしました

wiki>Mam711: /* Limit Distance Constraint */ grammar

2013-07-01T13:35:11Z

‎Limit Distance Constraint: grammar

新規ページ

{{Page/Header|2.5|Doc:2.5/Manual/Constraints/Transform/Copy Transforms|Doc:2.5/Manual/Constraints/Transform/Limit Location}}

= Limit Distance Constraint =
== Description ==
The {{Literal|Limit Distance}} constraint forces its owner to stay either further from, nearer to, or exactly at a given distance from its target. In other words, the owner’s location is constrained either outside, inside, or at the surface of a sphere centered on its target.

When you specify a (new) target, the {{Literal|Distance}} value is automatically set to correspond to the distance between the owner and this target.

{{Warning/Important}}Note that if you use such a constraint on a ''connected'' bone, it will have no effect, as it is the parent’s tip which controls the position of your owner bone’s root.

== Options ==
[[File:25-Manual-Constraints-Transform-LimitDist.png|thumb|304px|{{Literal|Limit Distance}} panel]]
; {{Literal|Target}}: This constraint uses one target, and is not functional (red state) when it has none.
:; {{Literal|Bone}}: If {{Literal|Target}} is an {{Literal|Armature}}, a new field is displayed offering the optional choice to set an individual bone as {{Literal|Target}}.
::; {{Literal|Head/Tail}}: If a {{Literal|Bone}} is set as {{Literal|Target}}, a new field is displayed offering the optional choice of where along this bone the target point lies.
:; {{Literal|Vertex Group}}: If {{Literal|Target}} is a {{Literal|Mesh}}, a new field is displayed offering the optional choice to set a {{Literal|Vertex Group}} as target.

; {{Literal|Distance}}: This numeric field sets the limit distance, i.e. the radius of the constraining sphere.
; {{Literal|Reset Distance}}: When clicked, this small button will reset the {{Literal|Distance}} value, so that it corresponds to the actual distance between the owner and its target (i.e. the distance before this constraint is applied).

; {{Literal|Clamp Region}}: The {{Literal|Limit Mode}} drop-down menu allows you to choose how to use the sphere defined by the {{Literal|Distance}} setting and target’s center:
:; {{Literal|Inside}} (default): The owner is constrained ''inside'' the sphere.
:; {{Literal|Outside}}: The owner is constrained ''outside'' the sphere.
:; {{Literal|Surface}}: The owner is constrained ''on the surface'' of the sphere.
{{clr}}

{{Page/Footer|Doc:2.5/Manual/Constraints/Transform/Copy Transforms|Doc:2.5/Manual/Constraints/Transform/Limit Location}}

[[Category:Constraints]]

← 古い版	2018年6月28日 (木) 19:42時点における版
(相違点なし)

Doc:2.6/Manual/Constraints/Transform/Limit Distance - 版の履歴

Yamyam: 1版 をインポートしました

wiki>Mam711: /* Limit Distance Constraint */ grammar

Yamyam: 1版をインポートしました