Yamyam: 1版をインポートしました

2018-06-28T20:46:27Z

1版をインポートしました

wiki>Yaoyue 2012: /* Settings */

2012-09-07T12:13:34Z

‎Settings

新規ページ

{{Page/Header|2.6||}}{{review|im=need the settings panel image}}

= Smoke Flow object =

== Create a Flow Object ==

Once you have defined the volume that will contain smoke, we'll add an object from which the smoke will be emitted. Add another cube and make sure it's inside the domain cube {{Shortcut|shift|A}}{{Menu|type=popup|Mesh|Cube}}; 3D view must be selected).

While in edit mode go to physics and add smoke to the small cube, too. This time chose Flow.

The smoke will not be emitted from the object itself but from particles the object emits. So we need to set up a particle system. With the small cube still selected go to the particle tab. Add a new particle system and turn off the physics because we want our smoke emit from stationary place. We also don't want to see the particles so turn off the render, too.

{| align=center
|[[File:Particles_tab.png|thumb|200px|The particles tab is right next to the physics tab]]
|[[File:No_physics.png‎|thumb|200px|We don't want the particles to be affected by physics]]
|[[File:No_render.png|thumb|200px|We also don't want to see the particles]]
|}

Now go back to the physics tab and chose the particle system in the smoke section. There should be a list with just one system to chose from that is called 'ParticleSystem' since we did not change the name. Now you can scrub through the timeline to see smoke coming from the cube. Another way to preview the smoke is starting the animation by {{Shortcut|alt|A}} (stop it the same way).

{| align=center
|[[File:Chose_particle_system.png|thumb|200px|Select the newly created particle system here]]
|[[File:Scrub_timeline.png‎|thumb|200px|Either scrub on the timeline or use ALT+A]]
|[[File:Smoke_viewport.png|thumb|200px|Now there should be smoke in the viewport]]
|}

== Settings ==

;{{Literal|Outflow}}
:Delete smoke from simulation.
;{{Literal|Particle System}}
:Particle system emitted from the object.
;{{Literal|Initial Velocity}}
:Smoke inherits its velocity from the emitter particle.
;{{Literal|Multiplier}}
:Multiplier to adjust velocity passed to smoke.

'''Initial Values'''
;{{Literal|Absolute Density}}
:Only allow given density value in emitter area.
;{{Literal|Density}}
:Initial density value.
;{{Literal|Temp. Diff.}}
:Temperature to ambient temperar.

{{Page/Footer||}}

← 古い版	2018年6月28日 (木) 20:46時点における版
(相違点なし)

Doc:2.6/Manual/Physics/Smoke/Flow object - 版の履歴

Yamyam: 1版 をインポートしました

wiki>Yaoyue 2012: /* Settings */

Yamyam: 1版をインポートしました