Doc:2.6/Manual/Modeling/Meshes/Editing/Duplicating/Inset

提供: wiki
< Doc:2.6‎ | Manual‎ | Modeling‎ | Meshes‎ | Editing‎ | Duplicating
2018年6月29日 (金) 05:53時点におけるYamyam (トーク | 投稿記録)による版 (1版 をインポートしました)
(差分) ← 古い版 | 最新版 (差分) | 新しい版 → (差分)
移動先: 案内検索

Inset

Mode: Edit mode

Hotkey: I

Menu: Mesh » Faces » Inset or CtrlF » Inset


This tool takes the currently selected faces and creates an inset of them, with adjustable thickness and depth. The tool is modal, such that when you activate it, you may adjust the thickness with your mouse position. You may also adjust the depth of the inset during the modal operation by holding Ctrl.


Selection to inset
Selection with inset

Options

Inset Operator Settings
Boundary
Determines whether open edges will be inset or not.
Offset Even
Scale the offset to give more even thickness.
Offset Relative
Scale the offset by surrounding geometry.
Thickness
Set the size of the inset.
Depth
Raise or lower the newly inset faces to add depth.
Outset
Create an outset rather than an inset.
Select Outer
Toggle which side of the inset is selected after operation.