Doc talk:2.6/Manual/Modeling/Meshes/Editing/Duplicating

提供: wiki
< Doc talk:2.6/Manual‎ | Modeling‎ | Meshes/Editing
2018年6月29日 (金) 04:45時点におけるYamyam (トーク | 投稿記録)による版 (1版 をインポートしました)
(差分) ← 古い版 | 最新版 (差分) | 新しい版 → (差分)
移動先: 案内検索
to do

 Should be updated based on 2.4 current content…

Question

About creating a face by selecting 2 edges : how is determined the direction of the normal of the newly created face ? Is the selection order of the edges important for the orientation of this normal (and if so, in which order do the edges have to be selected to make sure to get the normal in the correct direction) ?

I'm asking this question because I used this mean to "repair" an accidentally deleted face in the middle of a mesh; I thus filled the "hole", but the resulting normal happened to be on the wrong side (i.e. turned inwards and not outwards the mesh).

Of course I could flip the normal, but if I ever use the "Mesh/Normals/Recalculate Outside" command, this normal reverts to inwards...

Same question of course when a face is created by selecting 3 or 4 vertices.

Amreg