Doc:2.6/Manual/Constraints/Transform/Copy Rotation
< Doc:2.6 | Manual | Constraints | Transform
Copy Rotation Constraint
The Copy Rotation constraint forces its owner to match the rotation of its target.
Options
- Target
- This constraint uses one target, and is not functional (red state) when it has none.
- Bone
- If Target is an Armature, a new field is displayed offering the optional choice to set an individual bone as Target.
- Head/Tail
- If a Bone is set as Target, a new field is displayed offering the optional choice of where along this bone the target point lies.
- Vertex Group
- If Target is a Mesh, a new field is displayed offering the optional choice to set a Vertex Group as target.
- X, Y, Z
- These buttons control which axes are constrained – by default, all three are on.
- Invert
- The Invert buttons invert their respective rotation values.
- Offset
- When enabled, this control allows the owner to be rotated (using its current transform properties), relative to its target’s orientation.
- Space
- This constraint allows you to choose in which space to evaluate its owner’s and target’s transform properties.
