Doc:2.6/Manual/Modeling/Meshes/Editing/Basics/Creating Faces and Edges

提供: wiki
< Doc:2.6‎ | Manual‎ | Modeling‎ | Meshes‎ | Editing‎ | Basics
2013年7月2日 (火) 13:21時点におけるwiki>Ideasman42による版
(差分) ← 古い版 | 最新版 (差分) | 新しい版 → (差分)
移動先: 案内検索


Page status (reviewing guidelines)

Page reviewed and in good shape

Make Edge/Face

Mode: Edit mode

Hotkey: F

Menu: Mesh → Faces → Make Face/Edge

This is a context sensitive tool which creates geometry by filling in the selection. When only 2 vertices are selected it will create an edge, otherwise it will create faces.


The typical use case is to select vertices and press F, however Blender also supports creating faces from different selections to help quickly build up geometry.


The following methods are used automatically depending on the context.


Isolated vertices.

Before
After

Isolated edges

Before
After

N-gon from edges: When there are many edges Blender will make an ngon, note that this doesn't support holes, to support holes you need to use the XXX Fill Faces tool.

Before
After

Mixed vertices/edges: existing edges are used to make the face as well as an extra vertex.

Before
After

Edge-Net: sometimes you may have many connected edges without interior faces.

Before
After

Point Cloud: when there are many isolated vertices, Blender will calculate the edges for an n-gon.

Before
After

Single Vertex Selection: with a single vertex selected on a boundary, the face will be created along the boundary, this saves manually selecting the other 2 vertices. Notice this tool can run multiple times to continue creating faces.

Mesh face create boundary.png


Further Reading

For other ways to create faces see: