利用者:Sebbas/GSoC 2017/Reports/Week 10

Week 10

This week I was busy with exams. However, as promised, I created something "visually pleasing" with fluid guiding :)

What's been done

• Mantaflow has a built in test function that sets up a 2D velocity grid describing a spiral flow. My idea for a first fluid guiding test was to make use of this function and create a 3D smoke tornado (Gooseberry! :)

• Therefore I first had to adapt the spiral velocity function. I needed a 3D instead of a 2D target velocity grid for Mantaflow to work in Blender. (rB1f314b9ea5ca, rB1a914c0c0693)

• I then fitted all the necessary Python fluid guiding functions into the smoke script in Blender. The most important part here is to use the dedicated fluid guiding pressure function (it takes care of guiding and also the pressure solve). With this setup in place, the basic (tornado) guiding was working. (rB1b80047d1c3f)

Smoke (tornado) guiding in Blender

• To control the guiding just a bit I added a "Fluid guiding" tab to the UI. It lets you toggle guiding and also set a strength value. Note that this UI setup is meant to be just a temporary solution though. (rBd18ae102f34f)

Next up

• Next week I want to get back on track. Before fully focusing on guiding though I need to take a look at particles again. There are still some bugs when multiple particle types are enabled.

• The final fluid guiding setup should allow users to define arbitrary velocity fields (and not just tornados :). So a possible solution, which I'll try out, might be to use curves along which a velocity can flow.

Questions

• No