「Doc:2.6/Manual/Modeling/Meshes/Selecting/Faces」の版間の差分

提供: wiki
< Doc:2.6‎ | Manual‎ | Modeling‎ | Meshes‎ | Selecting
移動先: 案内検索
(Face Loops)
(相違点なし)

2014年9月7日 (日) 17:57時点における版

Selecting Faces

Activated the Face Select Mode

To select parts of a mesh face-wise, you have to switch to Face Select Mode. Do this by clicking the button shown above, or press Ctrl⇆ Tab to spawn a menu. The selection works as usual with RMB Template-RMB.png ; to add/remove to an existing selection, additionally press ⇧ Shift

Face Loops

Mode: Edit Mode (Mesh)

Hotkey: AltRMB Template-RMB.png - or ⇧ ShiftAltRMB Template-RMB.png for modifying existing selection

Face Loops are pretty much the same as Edge Rings. If you want to select a Face Loop, there is no menu entry that works based on a selected face. Using Select » Edge Ring would select a "cross" with the prior selected face as the middle. If you want to avoid switching to Edge Select Mode to select a Face Loop, use the AltRMB Template-RMB.png shortcut.

Different Loopselect Operations on a grid in Face Select Mode

Note: Numbers correspond to images ordered from left to right

  1. Just the selected face.
  2. Select the face, then Select » Edge Ring. See, how Blender selects edges, even if being in Face Select Mode. If these edges are desired and you want to work on them, switch to Edge Select Mode. Switching to Vertex Select Mode would flood the selection and leave you with the 4th image as result, that is, after having gone back to Face Select Mode after Vertex Select Mode.
  3. Select the face, the Select » Edge Loop. As in the example above, Blender pretends to be in Edge Select Mode and takes the four edges of the selected face as base for the selection operation.
  4. This selection was created by AltRMB Template-RMB.png on the left edge of the center face, followed by twice ⇧ ShiftAltRMB Template-RMB.png on the top edge of the center face. Two times, because the first click will remove the selected face loop (in this case, just the original selected face), while the second click will add the whole vertical running loop to the selection, creating the cross.

Ngons in Face Select Mode

Ngon-Face having its center dot inside another face

As already known, faces are marked with a little square dot in the middle of the face. With ngons that can lead in certain cases to a confusing display. The example shows the center dot of the U-shaped ngon being inside of the oblong face inside the "U". It is not easy to say which dot belongs to which face (the orange dot in the image is the object center). Luckily, you don't need to care much - because to select a face, you don't have to click the center dot, but the face itself.

Blender3D FreeTip.png
Face selection
To select a face:
Click the face, not the dot!